Functional Description - Makita BST110 Bedienungsanleitung

power.
2. Never recharge a fully charged
cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room
temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F).
Let a hot battery cartridge cool down before
charging it.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
Fig.1
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the front of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can
see the red part on the upper side of the button, it
is not locked completely. Insert it fully until the red
part cannot be seen. If not, it may accidentally fall
out of the tool, causing injury to you or someone
around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Safety system
WARNING:
Make sure all safety systems are in working order
•
before operation. Failure to do so may cause
personal injuries.
Fig.2
Fig.3
Test safety systems for possible faulty operation before
stapling as follows.
1. Make sure that the tool is not loaded with staples
before the test.
2. The tool accidentally operates if only the trigger is
pulled although the lever is not pulled.
3. The tool does not operate when the trigger is
pulled with the lever pulled.
In case of 2 and 3 above, the safety systems are faulty.
Trigger and lever
WARNING:
Always be sure that the tool is switched off before
•
inserting the battery cartridge on the tool.
Fig.4
battery
Fig.5
The tool is provided with lever as a safety system in
addition to the usual trigger.
To fire staples, first pull the lever and then pull the
trigger.
ASSEMBLY
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger or the lever and the battery cartridge
is removed before carrying out any work on the pin
nailer.
Staples
Handle the staples and their box carefully. If the
•
staples have been handled roughly, they may be
bent out of shape, causing poor staple feed or
jamming.
Avoid storing the staples in a very humid or hot
•
place or place exposed to direct sunlight.
CAUTION:
Do not use staples other than designated in this
•
manual or staples that appear to be damaged, bent,
rusty or corroded.
Do not insert staples of which size is different each
•
other at the same time inside the magazine ,
causing poor staple feed or jamming.
Loading staples
Remove the battery cartridge.
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
Fig.6
Load staples into the main magazine with their feet
facing up. Slide the sub-magazine forward.
Fig.7
To secure the sub magazine in place, hook the locking
lever on the rear of the sub-magazine.
CAUTION:
With the magazine loaded, if the tool is held
•
downward and the sub-magazine is opened, the
staples can fall out and present a danger to anyone
or anything below. Keep this in mind especially
when working in high locations.
Unloading staples
CAUTION:
When removing staples, make sure that your
•
fingers are not placed on the trigger or the lever
and the battery cartridge is removed from the
stapler. Misfiring may cause personal injuries and
property damage.
5