Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions ANSMANN
GB
Rechargeable Torch RC 1
(Part No. 5101102)
Page 1
USE OF THE TORCH
The RC 1 is a rechargeable torch with krypton bulb (KR 2.2V/0.5A/P13.5). It is powered by a 2.4 V NiMH
battery pack with 1,200 mAh and can be recharged direct at any 230 V mains socket. The magnet allows the
torch to be stuck to any magnetic surface.
CHARGING
Charge the torch before using it for the first time. To charge, remove the
complete bottom part of the lamp (consisting of battery pack, charging
electronics and power plug) from the slot. Connect it to a 230 V mains
socket. The integrated rechargeable battery pack is then being charged with
a charging current of approx. 120 mA. The charging time up to the
maximum charge is around 10 hours. The battery pack can be left attached
to the mains until it is needed. The lamp is charged continuously to avoid
losing capacity.
OPERATING TIME
The operating time of the RC 1 torch is around 120 minutes.
OPERATION
If you want to use the torch, disconnect the battery pack from the mains. By pushing the slide switch towards the
head of the lamp, the torch is switched on. The integrated magnet at the lower part of the torch allows the lamps
to be stuck to metallic surfaces when in operation.
REPLACING THE BULB
Turn the head of the torch anticlockwise and remove the reflector and the bulb. The bulb can now easily be
replaced. A spare bulb is attached to the inside of the lamp head.
ACCESSORIES
Includes: blue carrying strap, 230 V power supply. Charging electronics and 1,200 mAh/2.4 V battery pack are
integrated in the torch.
A mains adaptor plug for UK is available as special accessory.
Werbung
