Kärcher BD Trike BAT Betriebsanleitung Seite 30

Operating Instructions
BR Eco
Caution!
Ensure that the polarity is correct!
Clamp the supplied connection cable to
the remaining free battery terminals (+)
and (–).
Unlock the support and swivel back the
water tank and cover.
Insert the battery cover.
Tighten the star knob.
Caution!
Before switching on the unit,
charge the batteries!
Charging the batteries
Information:
i
The unit features deep-discharge
protection, i.e. if the still permitted minimum
capacity value is reached, the brush motors
and the turbine are switched off. In this
case the battery charge status display on
the control console illuminates red. From
this moment on the unit can only be driven.
Drive the unit directly to the charging
station, avoiding any inclines.
Information:
i
If using other batteries (e.g. another
manufacturer), the deep-discharge
protection for the particular battery must be
re-adjusted by Kärcher customer service.
30
Danger of electric shock!
!
Note power supply system and
fusing – see "Battery charger". Never use
the battery charger in rain, in high
atmospheric humidity or in damp rooms!
Information:
i
The battery charging process lasts
on average 10– 15 hours.
The recommended battery chargers (which
correspond to the utilised batteries) are
electronically controlled and end the
charging process automatically.
Charging process for BR/BD Trike
package
Insert the connection cable plug into the
socket.
Information:
i
All functions of the unit are automati-
cally interrupted during the charging process.
Charging process BR/BD Trike BAT
Danger of explosion!
!
Open the hood before charging lead-
acid batteries.
Remove the battery cover.
Lift up the water tank and cover and
engage the support.
Remove the battery connector and
connect to the charger cable.
Switch on battery charger.
After charging the battery:
Switch off the battery charger and
disconnect from the power supply.
Remove the charging cable and connect
to the battery plug connection.
English