Kärcher BD Trike BAT Betriebsanleitung Seite 32

Operating Instructions
Recommended battery chargers.
Manufacturer Description
KÄRCHER LG 242544-ob-wa-23
6.654-072 for low-maintenance
batteries 24 V
KÄRCHER LG 242544-ob-wf-23
6.654-078 for maintenance-free
batteries 24 V
A supply cable/adapter 6.648-582 is
required for both battery chargers.
Batteries and battery chargers are
available from specialist outlets.
Maximum dimensions
Length
Battery 520 mm
set (4x)
Single 260 mm
battery
The following is to be observed if lead-acid
batteries are used in the BAT variant:
– Lead-acid batteries must be housed in
a battery container (accessory).
– Observe the maximum battery
dimensions.
– The tank must be folded open while
charging lead-acid batteries.
– When charging lead-acid batteries,
comply with the regulations of the
battery manufacturer.
Attaching the steering wheel
Attach the steering wheel and tighten
the clamping screw.
Caution!
The steering wheel must be attached
firmly; observe the minimum insertion
depth of 65 mm.
32
Width Height
380 mm 290 mm
190 mm 290 mm
Unloading the unit
Risk of injury!
!
To stop all functions immediately,
press the red Emergency STOP pushbutton.
Place the long, lateral planks from the
packaging on the pallet and form a ramp.
Secure the planks with nails.
Support the ramp by placing the shorter
planks underneath.
Remove the wooden laths.
Raise the cleaning head with the pedal
and lock it.
Set key switch to "I".
Press "Direction-of-travel" pushbutton
and slowly run the unit down the ramp.
Set key switch back to "O".
Attaching the brushes
BD Trike
Before switching on the unit, the disc
brushes must be attached
(see "Maintenance procedures").
Attaching the suction bar
Unlock the suction bar pedal.
Insert the suction bar into the suction-
bar suspension device, ensuring that the
profiled sheet is situated over the
suspension device.
English