Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
For changing the oil and other maintenance operations on the motor (spark plugs, air filter, regulations), refer to the motor
manual provided.
NB: To unscrew the oil drain plug of the motor, disassemble the rear cover (Fig. 8 Ref. B).
Make a regular check of the oil level in the gearbox with the cap (Fig. 5 Ref. A) and topping up if necessary.
Change the oil completely every 200 hours. Empty the gearbox of oil by unscrewing the oil drain plug (Fig. 5 Ref. C)
Let the oil drain completely. After screwing back the cap tightly, fill to the correct level with new oil recommended by the
manufacturer. Fig. 5 Ref. "A".
If the grass is not cut in a satisfactory manner despite the adjustments, the blade must be sharpened or replaced. For
replacement as follows :
1. Remove the cable of motor spark plug.
2. Put on a pair of gloves.
3. Unscrew the grass divider (Fig.1 - Ref. "6").
4. Loosen the 4 knife holder.
5. Remove the blade and put the new or the sharpened one, only after having greased it.
6. Rescrew the knife holder, adjusting them in such a way as the blade can slide well.
7. Fasten the grass divider and reapply the cable of the spark plug
Fasten the grass divider and reapply the cable of the spark plug
For any mechanical repair, especially during the warranty period, we recommend to go to a specialised repair shop of the
dealer.
For transporting convenience, the handles can be disassembled by means of the two knobs (Fig. 8 Ref. A). The same is
recommended for the cutting bar, which is easily disassembled by removing the special split pin on the bar support (Fig. 9).
Always use gloves and apply the protective strip to the blade.
Regularly check that screws are tight. Pay special attention to the screws fastening the bar to its support
CAUTION
It is advised not to keep the motor running when the machine is not
being used for its specific purpose
Declaration of CE conformity in accordance with the directive 98/37 CE and the directive EMC 89/336/CE
Kleinmotoren GmbH, Stuttgarter Straße 41, D-71069 Sindelfingen
We declare that the machine complies with the essential requirements for health and safety in accordance with Directive
98/37/CE.
For verification of the conformity with the above-mentioned Directives reference has been made to following specifications: UNI
EN ISO 12100-1 and UNI EN ISO 12100-2; UNI EN 12733 for pushed motor mowers with rotating cutting blades or with
reciprocating motion used in agriculture, forestry and horticulture.
SOLO Kleinmotoren GmbH
Wolfgang Emmerich
Geschäftsführer
TYPE POWER MOWER
Acoustic pressure to the operator's ear: LpA 82 dB (A)
Testing conditions height 1.6 m handle midpoint.
Vibration to handles with weighting UNI EN 1033-1 value 4,9 m/s 2 .
This declaration of CE conformity is valid only if the product doesn't undergo any changes or modifications without authorization.

MAINTENANCE

SAFETY TESTS AND CERTIFICATION
POWER MOWER TYPE
RESULT AND TESTS
MODEL SOLO 531
.
MODEL SOLO 531
SINDELFINGEN, 18/01/2006
11

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis