Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual PORTY Lithium Power Pack
13:
READY
13:
READY
10:
AUDIO
10:
AUDIO
9:
RC/CH
15
12:
LAMP
16
READY
The READY indicator 13 lights up when the capacitors are
charged to the desired value; only in this case flashes can be
triggered via the synchronization socket, SLAVE, TEST or radio
signal.
Readiness to flash
Readiness to flash is signalled by
•
green light of the READY control lamp 13
•
acoustical signal when AUDIO is switched ON (green light
of the control lamp of switch 10)
AUDIO
An acoustical signal that can be turned on or off by pressing
switch 10 indicates:
•
Readiness to flash after charging (1x)
•
Automatic shut-off (3x)
Acoustical error signal
If an error occurred, an acoustical signal of 3 seconds duration
is given independent of the AUDIO switch setting.
RC/CH
A short tap on button RC/CH 9 switches the radio control unit
on (Control LED lights up) or off. A long press on button 9
changes to the channel selection mode; the green display is
flashing. A channel (1 – 3) can be selected by using the arrow
keys beside display 15. After approximately 3 seconds, the
displayed channel setting is stored. The display changes to the
flash power setting.
Modeling lamp
The PORTY Li power pack offers various modeling light options
For EH Pro Mini Head, the rocker switch has to be placed to
middle position.
A short tap on button 12 switches the modeling lamp on for
about 30 sec. (LED is blinking) during which the light can only
be switched off by flash triggering. Pressing button 12 for longer
than 2 sec. switches to continuous operation (LED runs
continuously). The modeling lamp is switched off by a repeated
short tap on button 12. The Strobe Wizard Plus transmitter can
only switch on the modeling lamp for 30 sec.
If 2 flash heads are connected, a modeling lamp of max 65W
halogen per each flash head is permitted.
HENSEL Studiotechnik
Werbung
Kapitel
Inhaltsverzeichnis
