Error Messages; Technical Data; Accessories - IKA IKATRON ETS-D5 Betriebsanleitung

Error messages

The following error messages may be displayed (Fig.5) and have
the causes listed below:
Er 1 Sensor not connected or defective (open circuit).
Er 5 Sensor not in media (no change in temperature of the
media after heater active for 3 minutes).
Er 6 Sensor short circuit.
Er 7 Maximum temperature for the media exceeded
(HI-TEMP setting).
Er 8 Calibration error (re-calibration by field service required).

Accessories

H 16 V Support rod
H 38 Retaining bar
H 44 Cross sleeve
H 50 Twin-jack adapter
H 52 Power supply kit
H 62 Standard sensor 270 mm stainless steel
H 66 Glass sensor
H 70 Extension cable, 1 m long
AD-C1 Adapter (for Corning magnetic stirrer)
12
270 mm glass

Technical data

Measuring range: °C -50 ... 450
Resolution: K 0.1)
Measuring accuracy: K ±0,2 + sensor tolerance PT 1000
DIN IEC 751 Class A
Setting accuracy: K 0,1
Type of control: PID
Control deviation: K ± 0,5
(500 ml water in 600 ml glass beaker,
magnetic stirring bar 40, 600 min- , 50 °C)
1
Supply voltage: V DC 8 ... 16 (Limited Power Supply)
Current consumption: mA 8 (at 9V)
Ambient temperature: °C 0 ... 60
Relative humidity: % 80
Duty cycle: % 100
Protection type: IP 54
Cable length: mm 350
Male connector: 6-pin DIN 45322
Socket: DIN 12878 Class 2
Dimensions: (W x D x H) mm 80 x 20 x 90 (without sensor)
Weight: kg 0.2
ETSD5 0306