Fronius Acctiva easy 1204 Bedienungsanleitung Seite 22

Establishing
connection to
battery/discon-
necting
Establish a connection as follows:
1. Unplug the charger from the mains
2. Plug charger lead into charger socket
3. Connect (+) charging terminal to positive pole (red) on battery
4. Connect (-) charging terminal to negative pole (black) on the battery, or to vehicle body
If using an on-board plug or a system plug to connect the charger lead, steps 3 and 4 do
not apply. Instead, connect charger cable to a suitable on-board socket or system
socket.
Testing and The on-board socket can be supplied in different ways, depending on the vehicle manuf-
charging acturer. Before testing or charging, refer to vehicle manufacturer's instructions.
(* only for chargers
used in vehicle
applications)
Open circuit voltage
Startability*
Alternator*
Charging
+ recommended
Important! The best results are obtained by connecting the charger directly to the
battery.
WARNING! Risk of explosion from short circuits and arcs. Before connecting
to/disconnecting from battery, disconnect charger from mains supply. During
operation, check that charging terminals and battery poles are properly con-
nected.
(e.g. engine block) in the case of vehicle power supplies.
NOTE! When disconnecting, it is imperative to follow the above instructions in
the reverse order in order to avoid short circuits and arcs.
Direct to
battery
+
+
+
+
o possible
On-board socket On-board socket
(+)* (+) switched off
when motor is
started.*
+ +
o -
+ +
+ +
- not possible
2
On-board socket On-board socket
switched on by switched on by
ignition.* ignition.
Switched off
when motor is
started.*
o o
o -
o o
- -