Filling With Water; Filling The Coffee Bean Container; Switching On For The First Time - Electrolux ECG6400 Gebrauchsanweisung

822_949_353 ECG6400_Elux.book Seite 110 Montag, 28. Januar 2008 11:57 23
g
6.2

Filling with water

Each time before switching on the cof-
fee machine, check that there is water
in the water tank, and refill if neces-
sary. The coffee machine requires water
for the automatic rinsing processes
each time the machine is switched on
or off.
0 Remove the water tank from the cof-
fee machine (Fig. 6). Before the tank is
removed, the steam nozzle must
always be positioned towards the cen-
tre of the appliance, otherwise the
tank cannot be removed.
0 Fill the water tank with fresh cold
water. Never exceed the MAX line.
Pour only fresh cold water into the
3
water tank. Never put in other liquids,
e.g. mineral water or milk.
0 Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
To always be sure of obtaining a rich
3
coffee with a full aroma, you should:
– change the water in the water tank
daily,
– wash the water tank at least once a
week in normal washing-up water
(not in the dishwasher). Then rinse
with fresh water.
6.3

Filling the coffee bean container

0 Raise the lid of the coffee bean con-
tainer, and fill the container with fresh
coffee beans (Fig. 7). Then reclose the
lid.
Note! Ensure that you use only pure
1
coffee beans with no caramelised or
aromatised additives. Do not use frozen
beans. Make sure that no foreign
objects, such as small stones, enter the
coffee bean container. Blocking or
damage caused by foreign objects in
the grinder might be excluded from
the guarantee.
3 The grinder is factory-set to a medium
grinding texture. If necessary, you can
change this setting. Notes on changing
110
the grinder setting can be found in
„Setting the grinding texture",
page 118.
1 The grinder settings may be changed
only whilst coffee is being ground.
Making adjustments to the stationary
grinder can damage the coffee
machine.
3 Coffee has been used to factory-test
the appliance, and it is therefore com-
pletely normal for there to be traces of
coffee in the mill. This appliance is
however guaranteed to be new.
6.4

Switching on for the first time

When you operate the machine for the
first time, the automatic switching on
process only continues if you have
selected the desired language.
0 Switch on the machine with the main
switch on the rear of the machine
(Fig. 8).
The display shows the text «PRESS
MENU TO CHOOSE ENGLISH»
successively in all available languages.
0 Wait for the correct language and
press the "Menu" key to confirm
(Fig. 4) and keep it pressed until the
display shows: «ENGLISH INSTAL-
LED».
3 After using the machine for the first
time you can change the language at
any time; see „Setting the language",
page 118.
After programming the language, the
display shows «FILL TANK !».
0 Fill the water tank; see „Filling with
water", page 110.
0 Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
The display now shows:
«TURN STEAM KNOB».
0 Move the steam nozzle outwards and
place a cup underneath it (Fig. 9).
0 Turn the knob for steam and hot water
anticlockwise as far as it will go to the
position (Fig. 10).