Maintenance; Regular Functional Check; Functional Check With Fumes (Optional) - Bosch FERION 3000 OW Handbuch

en | Notices
32
3.
4.
5.
6

Maintenance

The smoke detector function must be checked once a month.
6.1

Regular functional check

Press the test button for two seconds.
–
–
–
6.2

Functional check with fumes (optional)

For testing the detector with fumes you may use a test gas,
available in selected stores and online.
4
48 seconds after the smoke has escaped from the detector, the
alarm ends.
2014.09 | 4.3 | F.01U.249.486
Detach the connection terminal (green). If necessary loose
the cable inserts (orange).
Insert the stripped wire ends into the connection terminal.
Consider the correct polarity according the polarity stamp
in the housing.
Insert the connection terminal into the housing.
If the siren sounds (short beep) and the alarm light (red
LED) flashes 10 times, the smoke detector is working
correctly. The emergency lighting (white LED) is not
activated.
If the alarm light (red LED) flashes every second, the smoke
detector is defective and must be replaced.
If there is neither an audible nor visible signaling, the
battery is flat or the smoke detector is defective.
In this case replace the batteries and repeat the functional
check.
Spray several times into the detector to make sure that the
test smoke will remain inside the smoke chamber for at
least 16 seconds.
An alarm is triggered (siren, alarm light and emergency
lighting).
FERION 3000 OW
Bosch Sicherheitssysteme GmbH