Herunterladen Inhalt Inhalt Diese Seite drucken

Setting The Working Positions; Switching On And Off - FLORABEST FLV 1200 A1 Originalbetriebsanleitung

Elektro-vertikutierer / rasenlüfter
Vorschau ausblenden Andere Handbücher für FLV 1200 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
G
B
E I
Operation
Please observe local regulations
concerning noise protection.

Setting the working positions

The implement has 4 principal position
settings:
Setting 0 :
This position sets the maximum safety spac
Setting 1 :
Set this position when working with a new
implement.
Settings 2 - 3 :
The working position can be lowered with
increased knife and sprung tine wear.
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
The implement is delivered with
the height set to the Transport
Position (0).
1. The implement must be switched off to
set the working position.
2. Pull the adjustment wheel for adjustment
(see
A
9) and turn it to the desired
position until it clicks into place.
Both wheels (right and left) must be in-
dividually set to the same position.
108
Transport position
Working position
Readjustment positions
The adjustment wheel is not intended
for height adjustment but rather to
compensate for wear. Selection of
a readjustment position without the
corresponding wear can overload
the motor and damage the cylinder.

Switching on and off

Before switching on the implement
ensure that it is not
in contact with any objects.
Keep your feet and hands
well away from the cylinder
and the ejector opening. Danger
of injury!
D
1. Place the implement on a level
lawn surface.
2. Connect the power cable (17)
with the extension cable.
3. Form a loop in the end of the
power cable and hang it into the
cable rain relief (18).
4. Connect the implement to the
mains voltage.
5. To switch on, press the unlocking
button (1) on the handle and
simultaneously press the starting
lever (2). Release the unlocking
-
button (1).
6. To switch off, release
the starting lever (2).
Overload protection: The motor
is automatically switched off
when the implement is overloaded.
Release the starting lever and allow
the implement a cooling down period
of approx. 1 minute to reset.
st

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 280238

Inhaltsverzeichnis