Specifications - Sony UDA-1 Referenzhandbuch

Specifications

Amplifier section
Reference Power Output
23 W + 23 W (4 ohms, 1 kHz, THD 10%)
Rated Power Output
20 W + 20 W (4 ohms, 1 kHz, THD 0.9%)
Speaker impedance match
4 ohms - 16 ohms
S/N ratio
LINE IN: 100 dB (short-circuit input, 20 kHz LPF, A Network)
USB IN: 100 dB (20 kHz LPF, A Network)
Frequency response
10 Hz - 100 kHz (+0 dB, –3 dB) (4 ohms, LINE IN)
Input section (digital)
USB REAR (USB-B jack)
USB 2.0 compatible
Supported format
PCM (Sampling frequency: 44.1 k/48 k/88.2 k/96 k/176.4 k/
192 kHz, data bit length: 16/24/32 bits)
DSD (2.8 M/5.6 MHz)
USB FRONT (USB-A jack)
USB 2.0 compatible
Supported format
PCM (Sampling frequency: 32 k/44.1 k/48 kHz,
data bit length: 16 bits)
COAXIAL jack
Input impedance: 75 ohms
Supported format
PCM (Sampling frequency: 32 k/44.1 k/48 k/88.2 k/96 k/176.4 k/
192 kHz, data bit length: 16/24 bits)
OPTICAL jack
Supported format
PCM (Sampling frequency: 32 k/44.1 k/48 k/88.2 k/96 kHz, data
bit length: 16/24 bits)
6
GB
Input section (analog)
Input sensitivity: 500 mV
Input impedance: 100 kilohms
Output section
LINE OUT
Output voltage: 2 V
Output impedance: 2.2 kilohms
2 Hz - 80 kHz (–3 dB)
PHONES
17 mW + 17 mW (8 ohms, THD 1%)
55 mW + 55 mW (32 ohms, THD 1%)
170 mW + 170 mW (300 ohms, THD 1%)
General and others
Power requirements
AC 220-240 V 50/60 Hz
Power consumption
On: 65 W
During standby mode: 0.3 W
Dimensions (approx.) (w/h/d)
225 mm × 74 mm × 262 mm
including projecting parts and controls
Mass (approx.)
4.0 kg
Supplied accessories
AC power cord (1)
Remote control (RM-ANU182) (1)
USB cable (1)
Quick Start Guide (1)
Reference Guide (this manual) (1)
Design and specifications are subject to change without notice.

Standby power consumption: 0.3 W