Cleaning The Instrument - testo 174 Bedienungsanleitung

6. Place battery compartment cover on the battery compartment
and close by turning to the right. Use a coin for this.
- The current reading is shown on the display.
7. Slide the data logger into the bracket of the interface.
8. Start testo ComSoft software and create a connection to the
data logger.
9. Reconfigure data logger or install the old stored configuration,
see separate testo ComSoft instruction manual.
- The data logger is once again ready for use.
7.2

Cleaning the instrument

CAUTION
Damage to the sensor!
> Ensure that no liquid enters the inside of the housing.
> If the housing of the instrument is dirty, clean it with a damp
cloth.
Do not use any aggressive cleaning agents or solvents! Weak
household cleaning agents or soap suds can be used.
Only use new branded batteries. If a partially used battery
is inserted, the calculation of the battery capacity is not
performed correctly.
The data logger must be reconfigured. To do so, the testo
ComSoft software must be installed on the computer and a
connection to the data logger must be set up (see
Connecting data logger to PC page 26).
7 Maintaining the product
31