Dell OptiPlex GX520 Schnellreferenzhandbuch Seite 26

You must complete all the steps to properly set up your computer. See the appropriate figures
that follow the instructions.
1 Connect the keyboard and mouse.
NOTICE:
2 Connect the modem or network cable.
Insert the network cable, not the telephone line, into the network connector. If you have an
optional modem, connect the telephone line to the modem.
NOTICE:
communications can cause damage to the network adapter.
3 Connect the monitor.
Align and gently insert the monitor cable to avoid bending connector pins. Tighten the
thumbscrews on the cable connectors.
NOTE:
Some monitors have the video connector underneath the back of the screen. See the
documentation that came with your monitor for its connector locations.
4 Connect the speakers.
5 Connect power cables to the computer, monitor, and devices and connect the other ends of
the power cables to electrical outlets.
6 Verify that the voltage selection switch is set correctly for your location.
Your computer has a manual voltage-selection switch. Computers with a voltage selection
switch on the back panel must be manually set to operate at the correct operating voltage.
NOTICE:
voltage that most closely matches the AC power available in your location.
NOTICE:
NOTE:
Before you install any devices or software that did not ship with your computer, read the
documentation that came with the device or software, or contact the vendor to verify that the device or
software is compatible with your computer and operating system.
NOTE:
Your computer may vary slightly from the following illustrations.
26
Quick Reference Guide
Do not attempt to operate a PS/2 mouse and a USB mouse simultaneously.
Do not connect a modem cable to the network adapter connector. Voltage from telephone
To avoid damaging a computer with a manual voltage-selection switch, set the switch to the
In Japan, the voltage selection switch must be set to 115-V.