Replacing The Computer Cover; Solving Problems - Dell OptiPlex 330 dcsm Schnellreferenzhandbuch

5 SATA drive connectors
(SATA0, SATA1)
7 power connector
(POWER)
9 RTC reset jumper (RTCRST)
11 battery socket (BATTERY)
13 PCI card connectors
(SLOT2 and SLOT3)
15 serial/ PS/2 connector (PS2/SER2)
17 floppy drive connector (FLOPPY)

Replacing the Computer Cover

CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1 Ensure that all cables are connected, and fold cables out of the way.
2 Ensure that no tools or extra parts are left inside the computer.
3 To replace the cover:
Align the bottom of the cover with the hinge tabs located along the
a
bottom edge of the computer.
Using the hinge tabs as leverage, rotate the cover downward to close it.
b
Snap the cover into place by pulling back on the cover release latch
c
and then releasing the latch when the cover is properly seated.
Ensure that the cover is seated correctly before moving the computer.
d
4 Move the computer to the upright position.

Solving Problems

Dell provides a number of tools to help you if your computer does not
perform as expected. For the latest troubleshooting information available for
your computer, see the Dell support website at support.dell.com.
6 front-panel connector
(FRONTPANEL)
8 SATA drive connectors
(SATA2, SATA3)
10 password jumper (PSWD)
12 PCI Express x16 card connector
(SLOT1)
14 internal buzzer (SPKR)
16 fan connector (FAN_CPU)
Quick Reference Guide
47