Raid Configurations; Raid Definitions - Asus M3A78-T Handbuch

5.4

RAID configurations

The motherboard comes with the AMD SB750 chipset that allows you to configure
Serial ATA hard disk drives as RAID sets. The motherboard supports the following
RAID configurations: RAID 0, RAID 1, RAID 5 and RAID 10.
5.4.1

RAID definitions

RAID 0 (Data striping) optimizes two identical hard disk drives to read and write
data in parallel, interleaved stacks. Two hard disks perform the same work as a
single drive but at a sustained data transfer rate, double that of a single disk alone,
thus improving data access and storage. Use of two new identical hard disk drives
is required for this setup.
RAID 1 (Data mirroring) copies and maintains an identical image of data from
one drive to a second drive. If one drive fails, the disk array management software
directs all applications to the surviving drive as it contains a complete copy of
the data in the other drive. This RAID configuration provides data protection and
increases fault tolerance to the entire system. Use two new drives or use an
existing drive and a new drive for this setup. The new drive must be of the same
size or larger than the existing drive.
RAID 5 stripes both data and parity information across three or more hard
disk drives. Among the advantages of RAID 5 configuration include better
HDD performance, fault tolerance, and higher storage capacity. The RAID
5 configuration is best suited for transaction processing, relational database
applications, enterprise resource planning, and other business systems. Use a
minimum of three identical hard disk drives for this setup.
RAID 10 is data striping and data mirroring combined without parity (redundancy
data) having to be calculated and written. With the RAID 0+1 configuration you get
all the benefits of both RAID 0 and RAID 1 configurations. Use four new hard disk
drives or use an existing drive and three new drives for this setup.
For Windows XP, If you want to boot the system from a hard disk drive included
in a RAID set, first copy the RAID driver from the support DVD to a floppy disk
before you install an operating system to a selected hard disk drive. Refer to
section 5.5 Creating a RAID driver disk for details.
5-44 Chapter 5: Software support