General Information - Hilti WSC 70-A36 Bedienungsanleitung

ORIGINAL OPERATING INSTRUCTIONS
WSC 70-A36 cordless circular saw
It is essential that the operating instructions
are read before the power tool is operated for
en
the first time.
Always keep these operating instructions to-
gether with the power tool.
Ensure that the operating instructions are
with the power tool when it is given to other
persons.
Contents

1 General information

2 Description
3 Accessories
4 Technical data
5 Safety instructions
6 Before use
7 Operation
8 Care and maintenance
9 Troubleshooting
10 Disposal
11 Manufacturer's warranty - tools
12 EC declaration of conformity (original)
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cover
pages. Keep these pages open while studying the oper-
ating instructions.
In these operating instructions, the designation "the
power tool" always refers to the battery-powered WSC
70-A36 circular saw.
1 General information
1.1 Safety notices and their meaning
DANGER
Draws attention to imminent danger that will lead to
serious bodily injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that
could lead to serious personal injury or fatality.
CAUTION
Draws attention to a potentially dangerous situation that
could lead to slight personal injury or damage to the
equipment or other property.
NOTE
Draws attention to an instruction or other useful informa-
tion.
16
Operating controls and parts 1
Battery
@
Release buttons with additional function (charge
; status display activation)
Charge status and fault display (Li-ion battery)
=
On / off switch
%
Switch-on interlock
&
Auxiliary grip
(
Drive spindle lockbutton
)
Hexagon socket wrench
+
Cutting angle scale
§
Clamping lever for cutting angle adjustment
Page
/
Clamping screws for the parallel guide
16
:
Clamping lever for cutting depth adjustment
17
·
45°cutting line indicator
19
$
0°cutting line indicator
19
£
Parallel guide (rip fence)
20
|
Pivoting guard
24
¡
25 Riving knife
Q
27
Base plate
28
W
Guard
28
E
Rotatable chip ejector
29
R
Drive spindle
30
T
Mounting flange
Z
Clamping flange
U
Clamping screw
I
Cutting depth scale
O
Riving knife fastening screws
P
Pivoting guard operating lever
Ü
Chip deflector guard
[
Chip deflector guard release
]
Angle extender for 50° cuts
Æ
1.2 Explanation of the pictograms and other
information
Warning signs
General
warning
Warning: Warning:
electricity caustic
substances
Warning: hot
surface