Use; Cleaning Hard Floors - Dirt Devil SPIDER M607 Bedienungsanleitung

7 Use

7.1 Cleaning hard floors

7 Use
WARNING:
Danger of injury! You can let the appliance
run unsupervised, however always be care-
ful not to step on it, this could cause you to
fall.
19
B
20
B
21
A
A
ATTENTION:
Although your cleaning robot recognises
drop-offs, we strongly advise against using
it on furniture and similar objects. It is not
suitable for this type of use.
1. Place the appliance in the middle of the
room to be cleaned.
2. Turn on the cleaning robot using the On/
Off switch (Fig. 19).
„
The two outside LEDs will be flashing al-
ternately.
„
After approx. 8 seconds the appliance will
start to move in "random mode" passes
(Fig. 20/A).
„
After approx. 3 minutes the appliance
changes to "gyro mode" and moves in ev-
er larger circles (Fig. 20/B).
„
In this mode, as soon as the appliance en-
counters an obstacle, it changes to "edge
mode" (Fig. 21/A). In this mode it travers-
es the edges of the room to be cleaned for
approximately 3 minutes.
„
Thereafter the cycle starts all over again
(Fig. 21/B).
„
If the appliance keeps hitting an object,
give it a light shove with your hand.
„
You can switch off the appliance at any
time.
„
When the capacity of the battery pack di-
minishes, the battery indicator "
continuously illuminated red and the appli-
ance will stop a short while later.
- If this is the case, the robot will then
beep every 60 seconds so that you can
easily find it. If the battery pack is com-
pletely empty, even this beep function
will stop.
- In this case, switch off the appliance and
charge the battery pack as described,
ZChapter 5, 'Charging the battery pack
in the appliance'.
" will be
43