Interface Unit; Removing And Attaching The Interface Unit Cover; Installing The Interface Unit - Magnescale Laserscale BL57-RE Anleitung

4. Interface Unit

4-1. Removing and Attaching the Interface Unit Cover

To set or check the functions, remove the four screws, and then take off the interface unit cover.
When attaching the interface unit cover, place the cover so that the protruding surface is on the connector
side, and then retighten the removed screws in their original positions.
Tightening torque ......... 0.3 N · m
• Be careful not to lose the screws when you remove them.
• When attaching the interface unit cover, be sure that the protruding surface is on the connector side.

4-2. Installing the Interface Unit

Use the supplied screws to secure and attach the interface unit.
Firmly screw in the output connector.
Screw/Tightening torque ... M2.6
Do not insert or remove the output connector while power is supplied to the interface unit.
BL57-RE
Fig. 4-1
×
5: 4 pcs. / 0.8 N · m
Fig. 4-2
Protruding surface
4-1
(E)