HeiTel CamDisc VG HNVR Schnellinstallationsanleitung Seite 19

HeiTel Digital Video GmbH - Quick Installation Guide CamDisc VG HNVR
Item Labelling/description
7 IP Camera
8
9 ISDN
10 Mic
11 Line in
12 Line out
Pin assignment
terminal block
Labelling/
Pin
description
1 RS-485–
2 RS-485+
⊥
3
4 RS-232 Tx
5 RS-232 Rx
⊥
6
7 Al a/d
8 V out
9 Al in
10 Aux in1
11 Control in 1-5
to
15
⊥
16
⊥
17
18 12/24 V +
⊥
19 12/24 V
CamDisc VG HNVR
Function
Socket RJ-45: Ethernet interface (10/100/1000 MBit/s)
primarily provided as the interface to the network of IP cameras
IP address on delivery or following a device reset: 192.168.32.95
M4 thread for earthing the video system
Socket RJ-45: ISDN interface (S0 bus) for optional
(analogue modem) for optional PSTN Card
Activation via optional ISDN Card or PSTN Card
Jack socket: Direct connection of an Electret or of an electrostatic microphone
Jack socket: Direct connection of an audio source with line level output
Jack socket: Direct connection of an audio source with line level input
34 pin terminal block
1
18
Type Function
Serial (D–) PTZ: Use this terminal to connect up to 10 remote control cameras or
other compatible devices (e.g. matrix) with RS-485/RS-422 interfaces.
Serial (D+)
Ground PTZ: Common ground for RS-232 interface
Serial TxD PTZ: Use this terminal to connect 1 remote control camera or one other
compatible device (e.g. matrix) with RS-232 interface.
Serial RxD
Ground Common ground for all inputs of type "control input"
Control input Arm/Disarm input for enabling/disabling dialup to a CamControl receiver
PC, controlled by "Control in", "Al in", and "Motion Detection"
"Wiring variants for voltage-monitored control inputs" on page
Control input Control input for manual activation of the HDD standby function
Control input Alarm input for dialup with automatic switching of video input 1 (V1 in)
to a CamControl receiver unit
monitored control inputs" on page
Control input Tamper input for dialup with automatic switching of video input 1 (V1 in)
to a CamControl receiver unit
monitored control inputs" on page
Control input Camera control inputs for external contact triggered recording and/or
selective dialup to a CamControl receiver unit for video inputs 1 to 5 (see
"Wiring variants for voltage-monitored control inputs" on page
Ground Common ground for all inputs of type "control input"
Ground Common ground for all inputs of type "control input"
Power, + Nominal voltage 12 - 24 V DC
The permissible supply voltage is 8 to 30 V DC. Ensure that the supply
Power, Ground
voltage remains within the permitted range in all operating modes.
ISDN Card or PSTN interface
17
34
(see "Wiring variants for voltage-
22).
(see "Wiring variants for voltage-
22).
(see
22).
22).
19