Create Wind Modern Bedienungsanleitung Seite 13

CA NOPY AS SE MB LY
1. Lift the rosette up to the mounting bracket and align the loosened screws in the moun-
ting bracket with the holes in the rosette.
2. Rotate the rosette to tighten and reinsert the screws.
3. Secure the screws with a screwdriver.
4. Then lift the decorative cover onto the rosette so that it is secured with the magnet
provided.
Tip: Seek the help of another person to hold the stepladder in place and to lift the fan up to you
once you are set on the ladder.
B L AD E S AS SE MB LY
1
Align the holes on the blade holder with the holes on the blades and the motor body and screw
them in place, but don't tighten them until they are all placed and screwed in.
Tip: To save time, you can fit the washers on each screw prior to installing the blades.
M OUN TI N G THE CONNECT I O N PANE L
• Attach the connection panel to the bottom of the fan by inserting the screw heads into
the holes provided.
• Screw in the screws and then secure them.
Note: While installing or removing the patch panel, carefully keep the insulation pads in-
tact. Turning the fixing screws too hard or too fast will damage the insulating pads.
Connection panel
Panel screws
2
E NGLI SH
13