Endress+Hauser RIA452 Betriebsanleitung Seite 125

RIA452
Function Parameter
(menu
item)
Totalizer 9999999
Reset total No
Yes
Calc. flow No
Curve
Formula
Dim. input mm
inch
Dec. flow XXXXX
XXXX.X
XXX.XX
XX.XXX
X.XXXX
Endress+Hauser
setting
In this position, the totalizer can be displayed and edited (e.g. assigned
a default value).
!
The counter starts again at 0 if the maximum value of 9999999 is
exceeded.
Reset totalizer
!
Cannot be configured via ReadWin
For selecting a method of calculating the total flow based on the
channel type or by means of a formula using the analog input signal
(e.g. level signal)
• No = no integration
• Curve = flow calculated with channel type.
If "Curve" is selected, the menu only displays possible channel types
for configuration (e.g. Venturi channels, Parshall channels, weirs
etc.)
• Formula = flow calculated using a formula
If "Formula" is selected, the menu only displays possible
configuration parameters for entering the formula (Alpha, Beta,
Gamma, C).
Here, the flow is calculated using the following formula:
Dimension of the channel size
Decimal point for display
Description
Note!
Note!
Commissioning
®
2000.
125