Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
■
Switch off the device after you finish
cleaning each surface to significantly
increase the operating time on each
battery charge. Charge up the battery
after use (see the "Charging Up the
Battery" chapter).
L
The device cannot be operated
when it is connected to the mains
power. Disconnect the connecting
cable (7) prior to use.
1. Select a nozzle (see the "Accessories"
chapter) and plug it into the suction
opening (20). You must hear it engage.
For a longer reach, plug the extension
tube (5) in between.
•
To pull a nozzle or the extension tube
out again, press the respective release
button.
2. Switch on the device and guide the
nozzle over the area to be cleaned. To
switch on at suction level 1, press the
On / Off button (10). You can press
the
button (9) to switch between
suction level 1 and 2.
3. Guide the nozzle over the area to be
cleaned.
4. To switch off the device, press the
On / Off button.
5. To ensure optimum performance of the
device, empty and if necessary clean the
dust container after every use (see next
chapter).
CLEANING AND STORAGE
Please Note!
■
Do not use any sharp or abrasive cleaning
agents to clean the device. They may
damage the surfaces.
L
The HEPA filter may lose some of
its colour over time. This is normal
and does not have any adverse
effect on function.
14
14576_14864_14866_15673_Inlay_DE-EN_A5_V2.indb 14
14576_14864_14866_15673_Inlay_DE-EN_A5_V2.indb 14
Emptying the Dust Container
1. Hold the device over an open dustbin
and pull the release (18) slightly out
wards. The dust container flap (17)
opens ( Picture D) and the dirt drops out.
2. To close it, press the dust container
flap onto the dust container. You must
hear it engage.
Cleaning the Dust Container,
Metal Filter and HEPA Filter
1. Open the dust container, reach in and
twist the bottom of the HEPA filter (15)
a little until it is detached.
2. Take the metal filter together with the
metal filter (16) out of the dust container.
3. Pull the metal filter off the HEPA filter.
4. Tap out both filters and clean them with
a soft brush if necessary. They can also
be rinsed out with clear water, but they
must be completely dry before they
are assembled!
5. Wipe the dust container with a damp
cloth if necessary and then dry it or allow
it to dry in the air. Never assemble wet
or damp components or attach them
to the motor unit!
6. When all components are dry, place the
metal filter back on the HEPA filter. Align
the recess on the metal filter (Picture B)
with the marking on the HEPA filter.
7. Insert the HEPA filter into the dust
container and twist it to secure it.
8. Close the dust container.
Cleaning the Exhaust Air Filter
1. Twist the filter compartment cover (8)
anticlockwise and take it off.
2. Pull the exhaust air filter out.
3. Tap out and brush out the exhaust air fil
ter and the exhaust air filter compartment.
The exhaust air filter can also be rinsed
out with clear water, but it must be
completely dry before it is assembled!
4. Insert the cleaned exhaust air filter into
the exhaust air filter compartment.
CLEAN edition
06.01.2025 12:09:52
06.01.2025 12:09:52
Werbung
