Cleanmaxx MC632 Gebrauchsanleitung Seite 13

Cordless hand & floor vacuum cleaner
■
Only use suitable extension cables
whose technical data is the same as
that of the power supply.
■
Pull the power supply out of the plug
socket if an error occurs during charging
or before a thunderstorm.
1. Plug the barrel connector of the
connecting cable (7) into the charging
socket (14).
2. Connect the power supply to a plug
socket. The charge control lamps (13)
start to flash and the battery (12) is
charging.
If all charge control lamps are constantly
lit, the battery is fully charged.
3. First disconnect the power supply from
the mains power and then disconnect
the barrel connector from the device.
ATTACHING THE WALL
MOUNTING BRACKET
Please Note!
■
If you are unsure whether the fixings
supplied are suitable for the wall, seek
advice from a specialist retailer.
■
Hang the wall mounting bracket in a
secure and fixed position close to an
easily accessible plug socket.
■
Before drilling, ensure that there are
no pipes or power cables behind the
intended drilling point.
1. Place the wall mounting bracket (3)
against the wall and mark out two drill
holes (at the top and bottom).
2. Drill holes into the wall and place
anchors in them.
3. Screw the wall mounting bracket onto
the wall.
14576_14864_14866_15673_Inlay_DE-EN_A5_V2.indb 13 14576_14864_14866_15673_Inlay_DE-EN_A5_V2.indb 13
ACCESSORIES
The crevice nozzle (1) is suitable for places
which are hard to get to, such as corners,
crevices or recesses. Upholstery and all
nooks and crannies that cannot be reached
with other nozzles.
The 2 in 1 upholstery and brush nozzle (2)
has a flexible brush attachment. Press the
button on it and slide it forwards or back­
wards until it engages (Picture C).
If the brush attachment is at the front, the
nozzle is suitable for dusting all uneven
objects, furniture, lamp shades, picture
frames, keyboards, books etc.
If the brush attachment is at the back, the
nozzle acts as an upholstery nozzle for
cleaning all kinds of upholstery (e.g. sofas,
car seats etc.).
The electric floor nozzle (6) is suitable for
both carpets and hard floors. It has LED
lighting and a rotating cleaning brush to
make it easier to pick up hair and fluff.
The extension tube (5) is intended to be
used with the floor nozzle for cleaning
floors. In addition, it makes it easier to
reach ceilings and corners.
The wall mounting bracket (3) is suitable
for storing the device.
USE
Please Note!
■
Make sure that there are no large, sharp
objects on the surface which is to be
cleaned.
■
While using the device, make sure that
the dust container does not get too full.
Empty the dust container regularly and
clean it after every use. The filters must
also be regularly cleaned in order to
prevent overloading of the motor (see
the "Cleaning and Storage" chapter).
EN
13
06.01.2025 12:09:52 06.01.2025 12:09:52