Herunterladen Inhalt Inhalt Diese Seite drucken

Ihr Kühlgerät Braucht Luft; Preparation Of Ice Cubes; Nischenmaße; Türanschlag Wechseln - AEG Electrolux ARCTIS G 7 72 50-6 i Gebrauchsanweisung

Integrierbarer gefrierschrank
Inhaltsverzeichnis

Werbung

Ihr Kühlgerät braucht Luft
Aus Gründen der Sicherheit muß
eine
Mindestbelüftungs-heit
gesichert sein, wie aus der Abb.
hervorgeht:
Achtung:
Die Lüftungs-Öffnungen müssen
immer saubergehalten werden.
Damit die Luft zirkulieren kann,
die Lüftungsöffnungen niemals
abdecken oder verstellen.
Nischenmaße
Höhe
720 mm
Tiefe
550 mm
Breite
560 mm
Türanschlag wechseln
Der Türanschlag kann von rechts (Lieferzustand) nach links gewechselt wer-
den, falls der Aufstellort dies erfordert. Je nach Türanschlag, Scharnierstift
auf einer Seite oben und unten entfernen.
Warnung! Während des Türanschlagwechsels darf das Gerät nicht am
Stromnetz angeschlossen sein. Vorher Netzstecker ziehen.
8
min.
50 mm
200 cm
2
min.
200 cm
2
D567

Preparation of Ice Cubes

1.
Fill the ice cube tray 3/4 full with cold water, place it in the freezer com-
partment and leave to freeze.
2.
To loosen the frozen cubes, either bend the ice cube tray or hold it under
running water for a few seconds.
Important! Never try to free an ice tray that is frozen to the freezer com-
partment using pointed or sharp edged objects. Use the ice scraper supplied.
Defrosting
Freezer
The freezer compartment, however, will become progrssively covered with
frost. This should be removed with the special plastic scraper provided, whe-
never the tickness of the frost exceeds 4 mm. During this operation it is not
necessary to switch off the power supply or to remove the foodstuffs.
However when the ice becomes very thick on the inner liner, complete
defrosting should be carried out as follows:
1.
Remove the frozen food from the
freezer, wrap it in several layers of
newspaper and put it in a very
cool place.
2.
Switch off the appliance and pull
out the plug, or remove or
unscrew the safety fuses.
3.
Leave the freezer compartment
door open.
4.
Insert the plastic scraper into the
recess provided under the defrost
water channel and place a collec-
ting basin under it.
5.
Once defrosting is completed keep the scraper for future use;
6.
Turn the thermostat knob to the required setting or replace the plug in the
power socket.
Warning!
Never use metal tools to scrape off the frost
Do not use a mechanical device or any artificial means to speed up the
thawing process other than those recommended by the manufacturer.
A temperature rise of the frozen food packs, during defrosting , may shor-
ten their safe storage life.
D068
57

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis