IKEA FRAMTID Bedienungsanleitung Seite 5

ENGLISH
If the refrigerant circuit should become dam-
aged:
– avoid open flames and sources of ignition
– thoroughly ventilate the room in which the
appliance is situated
• It is dangerous to alter the specifications or
modify this product in any way. Any dam-
age to the cord may cause a short-circuit,
fire and/or electric shock.
Warning! Any electrical component
(power cord, plug, compressor) must be
replaced by the After Sales Service agent or
qualified service personnel.
1. Power cord must not be lengthened.
2. Make sure that the power plug is not
squashed or damaged by the back of
the appliance. A squashed or damaged
power plug may overheat and cause a
fire.
3. Make sure that you can come to the
mains plug of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do not
insert the power plug. There is a risk of
electric shock or fire.
6. You must not operate the appliance
without the lamp cover
ing.
• This appliance is heavy. Care should be tak-
en when moving it.
• Do not remove nor touch items from the
freezer compartment if your hands are
damp/wet, as this could cause skin abra-
sions or frost/freezer burns.
• Avoid prolonged exposure of the appliance
to direct sunlight.
Daily Use
• Do not put hot pot on the plastic parts in the
appliance.
• Do not store flammable gas and liquid in the
appliance, because they may explode.
• Do not place food products directly against
the air outlet on the rear wall.
• Frozen food must not be re-frozen once it
has been thawed out.
1) If the lamp cover is foreseen
2) If the appliance is Frost Free
1)
of interior light-
2)
• Store pre-packed frozen food in accord-
ance with the frozen food manufacturer's in-
structions.
• Appliance's manufacturers storage recom-
mendations should be strictly adhered to.
• Do not place carbonated or fizzy drinks in
the freezer compartment as it creates pres-
sure on the container, which may cause it to
explode, resulting in damage to the appli-
ance.
• Ice lollies can cause frost burns if consumed
straight from the appliance.
Care and cleaning
• Before maintenance, switch off the appli-
ance and disconnect the mains plug from the
mains socket.
• Do not clean the appliance with metal ob-
jects.
• In case of accidental frost built-up (the prod-
uct is a no frost type), do not use sharp ob-
jects to remove frost from the appliance. Use
a plastic scraper.
• Regularly examine the drain in the refriger-
ator for defrosted water. If necessary, clean
the drain. If the drain is blocked, water will
collect in the bottom of the appliance.
Installation
Important! For electrical connection carefully
follow the instructions given in the specific
paragraph.
• Unpack the appliance and check if there are
damages on it. Do not connect the appli-
ance if it is damaged. Report possible dam-
ages immediately to the After Sales Service
(refer to "Service"). In that case retain pack-
ing.
• It is advisable to wait at least four hours be-
fore connecting the appliance to allow the
oil to flow back in the compressor.
• Adequate air circulation should be around
the appliance, lacking this leads to over-
heating. To achieve sufficient ventilation fol-
low the instructions relevant to installation.
5