Installation - IKEA FRAMTID Bedienungsanleitung

ENGLISH

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing
the appliance.
Location
Caution! It must be possible to disconnect
the appliance from the power supply. The
plug must therefore be easily accessible after
installation.
Install the appliance
well away from sour-
ces of heat such as ra-
diators, boilers, direct
sunlight etc. Make sure
that air can circulate
freely around the back
of the cabinet. To en-
sure best performance,
install the appliance at
least 100 mm between the top of the cabinet
and the wall unit. To allow the door to open,
install the appliance at least 60 mm between
the cabinet and the wall unit if the appliance
is placed in a corner and the side with the
hinges facing the wall. Accurate levelling is en-
sured by some adjustable feet at the base of
the cabinet.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate class
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
100mm
45 mm
10 mm
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Direc-
tives.
Rear spacers
In the accessory bag you find two spacers
which must be fitted as shown in the picture.
Slacken the screws and insert the spacer under
the screw head, then tighten the screws.
13