Werbung
Change door hinge
1. Open the door and unscrew the upper hinge (1) on the
right-hand side of the worktop.
2. Take the door out of the cupboard.
3. Remove the screws (2) on the left side of the worktop.
4. Remove the hinge cover (3/4) from the upper left side of
the door and the cover cap on the upper right side of the
door and swap their positions.
5. Remove the door stop (5) from the lower right side of the
door and attach it to the lower left side of the door.
6. Remove the lower hinge (6) on the lower right side of the
cabinet and then attach it to the lower left side of the
unit.
7. Fit the lower hinge (6) on the lower left side.
8. Fix the door on the lower hinge (6) .
9. Fit the upper hinge (1) on the upper left side of the
worktop.
Set up unit
The device
•
set up according to the prescribed minimum distances.
•
place in a well-ventilated and dry room with an ambient temperature
corresponding to the climate class for which the appliance is designed.
ATTENTION
BEWARE!
Leave the unit for 12 hours after transport to allow the refrigerant to collect in the
compressor. Failure to do so could damage the compressor and cause the unit to fail. In
this case, the warranty will be invalidated.
The climate class can be found on the type plate (inside or on the back of the appliance)
and on the product data sheet. The ambient temperature affects the power consumption
and the proper functioning of the appliance.
CLASS
(SN) extended temperate zone
(N) temperate zone
(ST) subtropical zone
(T) tropical zone
GS581-051CB
STEP SEQUENCE
Version 12-2023
TEMPERATURE RANGE
+10 °C to +32 °C
+16 °C to +32 °C
+16 °C to +38 °C
+16 °C to +43 °C
IMAGE
page 9
Werbung
