Control Panel - Electrolux EUC19291W Benutzerinformation

4 electrolux
• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
SERVICE
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
ENVIRONMENT PROTECTION
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1
1. Alarm light
2. Pilot light
3. Action Freeze button
Alarm reset button
4. Action Freeze light
5. Temperature regulator
SWITCHING ON
Insert the plug into the wall socket.
The pilot light will light up.
Turn the Temperature regulator clockwise
to a medium setting.
Important! If the temperature inside the
appliance is too high the Alarm light will light
up.
SWITCHING OFF
To turn off the appliance, turn the Tempera-
ture regulator to the "O" position.
Important! The Pilot light stay ON until the
appliance is disconnected from the power
socket.
TEMPERATURE REGULATION
The temperature is automatically regulated.
2 3 4 5
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
To operate the appliance, proceed as fol-
lows:
• turn the Temperature regulator counter
clockwise to obtain warmer storage tem-
perature.
• turn the Temperature regulator clockwise
to obtain colder storage temperature.
A medium setting is generally the most
suitable.
The exact setting should be chosen keep-
ing in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
ACTION FREEZE FUNCTION
You can activate the Action Freeze function
by pressing the Action Freeze button.
The Action Freeze light will light up.
Important! This function stops
automatically after 52 hours.
It is possible to deactivate the function at
any time by pressing Action Freeze button.
The Action Freeze light will switch off.
HIGH TEMPERATURE ALARM
Temperature increase in the freezer com-
partment (for example due to an earlier
are recyclable.