Operation - IKEA LFC186/44 Bedienungsanleitung

ENGLISH
• Adequate air circulation should be around
the appliance, lacking this leads to over-
heating. To achieve sufficient ventilation fol-
low the instructions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor, con-
denser) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried out
by a qualified electrician or competent per-
son.
• This product must be serviced by the After
Sales Service, and only genuine spare parts
must be used. The service numbers are listed
in the Service information.

Operation

Switching on
Insert the plug into the wall socket.
Turn the temperature regulator clockwise to a
medium setting.
Switching off
To turn off the appliance, turn the temperature
regulator to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the temperature regulator toward low-
er settings to obtain the minimum coldness.
• turn the temperature regulator toward high-
er settings to obtain the maximum coldness.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its re-
frigerant circuit or insulation materials. The ap-
pliance shall not be discarded together with
the urban refuse and rubbish. The insulation
foam contains flammable gases: the appliance
shall be disposed according to the applicable
regulations to obtain from your local authori-
ties. Avoid damaging the cooling unit, espe-
cially at the rear near the heat exchanger. The
materials used on this appliance marked by
the symbol are recyclable.
A medium setting is generally the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside
the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high
or the appliance is fully loaded, and the
appliance is set to the lowest temperatures, it
may run continuously causing frost to form on
the rear wall. In this case the dial must be set
to a higher temperature to allow automatic
defrosting and therefore reduced energy
consumption.
6