FS L3 Schnellstartanleitung Seite 12

Quick Connect
Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Show quick connect on startup
Step 4: After setting the parameters, click Connect to enter.
Troubleshooting
The Power Module Cannot Supply Power
First, disconnect the power cord of the power module, then check the following:
1. Check whether the cable connections of the rack are correct.
2. Check whether the connection between the power socket and the power cord is loose.
3. Check whether the connection between the power module and the power cord is loose.
4. Check whether the power module inserts into place.
Connecting the Switch Remotely Unsuccessfully
1. Test the network connectivity through ping.
2. If the network is reachable, try restarting the switch.
3. Check whether the corresponding service is enabled.
The Optical Port Cannot Link Up
1. Check whether the receiving and delivering ends of the ber optical cable connect
correctly.
2. Check whether the wavelengths of transceivers of the interconnection are the same.
Serial
COM3
Flow Control
115200
DTR/DSR
8
RTS/CTS
None
XON/XOFF
1
Save session
Open in a tab
Connect Connect Cancel
x
11