Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Descripti on
Descripti on and layout diagram (Figure B) of the solar fi lter system
The device's integrated pump draws in pool water via the fi lter material and pumps it back into the pool aft er
it has been fi ltered. The fi lter system is not self-priming and must therefore be installed below the water level.
When operated with the PV panel, the fi lter system only works when there is suffi cient sunlight.
The device is equipped with connecti ons for Ø 32 mm swimming pool hoses.
Filter ti me
The water in the pool should be circulated at least twice within 24 hours. If the pool is heavily used, it should
be circulated 3 to 5 ti mes a day.
Initi al commissioning
Danger to life due to operati on of the water treatment system while bathing!
Hair or items of clothing can be sucked into the sucti on opening of the pool and, in extreme cases, trap people
under water and prevent them from surfacing.
» Never operate water treatment system devices while people are in the pool.
» Prevent all access to the pool while water treatment system devices are in operati on.
Flocculants in the bath water can cause the Filter Balls or Filter Wool Flakes to clump together and severely
impair their cleaning eff ect.
» Do not use fl occulants for water treatment if you are using Filter Balls or Filter Wool Flakes as a fi lter
medium.
Check before commissioning
» The appliance is outside the pool and the power cable is disconnected from the power supply
Assembly
» Assemble the appliance parts as shown in fi gure A and
the corresponding item numbers..
» Note that the union nut and the connecti ng elbow
are already pre-assembled.
» Moisten the two lower O-Rings
detergent.
» Push the connecti on elbow
4
and ti ghten the union nut
any tools for this as they could damage the union nut!
WARNING!
NOTE!
1
2
with a litt le water or
1
into the threaded cover
1
by hand. Do not use
040603_V2410
en
21
Werbung
