Dynacord cms 600-3 Bedienungsanleitung Seite 22

3
CMS
M
ENU STRUCTURE
Illustration 3-5: Menu structure of CMS
PLAY 11-12 MIDI PEAK AUX
BRIGHT HALL MONO DELAY
5 55
Large Hall 3 230 ms 40%
FX1 FX2
FX Control Setup
FX1 MIDI Channel
FX2 MIDI Channel
MIDI PrgCh Count
E FX 1 / FX 2
DIT
This dialog allows editing effect parameters for effect
unit FX 1 or FX 2. The available parameters will vary de-
pending on the effect type, see page 25 for details. Addi-
tionally a custom name can be assigned to the edited
effect and it can be stored as a user preset. Up to 20 user
presets can be created.
Illustration 3-6: Edit FX 1 dialog
Edit FX 1 BRIGHT HALL
Predelay :
Reverb Decay :
Diffusion :
Low Cut :
SAVE
Turn the MENU/ENTER rotary encoder to highlight an en-
try in the left column of the Edit FX Menu. Press the
MENU/ENTER rotary encoder to select the corresponding
value in the right column. Now turn the MENU/ENTER ro-
tary encoder to edit the value. Press the MENU/ENTER ro-
tary encoder again to return to the left column. Press the
SAVE function key to store the edited effect as an user
preset. The FX User Presets dialog appears.
22
Footswitch Ctrl.
TAP Button Ctrl.
FX1 Start Preset
FX2 Start Preset
16ms
40
25
50Hz
BACK ESC
Main Menu
Edit FX 1
Edit FX 2
AUX Mode
FX Control Setup
Device Setup
Illustration 3-7: FX User Presets dialog
FX 1 User Presets
101: --EMPTY--
102: --EMPTY--
103: --EMPTY--
104: --EMPTY--
Turn the MENU/ENTER rotary encoder to select the user
preset where the edited effect should be stored to. Press
the MENU/ENTER rotary encoder to open the Set FX
Name dialog.
Illustration 3-8: Set FX Name dialog
Set FX Name
D E F G H I J K L
L arge Hall 3
Device Setup
Display Brightness
Screensaver
Personalize
Show Device Name
Play 11-12 at STDBY
Factory Reset
Firmware Info
BACK ESC
M N O P Q R S T
OK BACK