Herunterladen Diese Seite drucken

Electrolux KNP7TE75S Benutzerinformation Seite 41

Vorschau ausblenden Andere Handbücher für KNP7TE75S:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 66
Problem
Water flows on the rear plate of the
refrigerator.
There is too much condensed water
inside the fridge.
There are water drops on the glass
shelves.
Water flows inside the fridge.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Possible cause
Appliance is fully loaded and is set
to the lowest temperature.
Temperature set in the appliance is
too low and the ambient tempera‐
ture is too high.
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
This is normal that during summer
and autumn more condensation can
form due to the increased air and
food humidity. Fridge does not pro‐
duce any moisture. After this period,
the humidity in the fridge decreases
itself.
There is too much moisture inside
the fridge.
Food prevents the water from flow‐
ing into the water collector.
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The Extra Freeze function or Extra
Cool function is switched on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food is too hot.
Too much food is stored at the
same time.
The door has been opened often.
The Extra Freeze function is switch‐
ed on.
Solution
Set a higher temperature. Refer to
"Control panel" chapter.
Set a higher temperature. Refer to
"Control panel" chapter.
This is correct.
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
In summer and autumn, set the
warmer temperature in the refrigera‐
tor (approx. 6-7°C).
Wipe the glass shelves with a cloth
to remove water drops.
Make sure that food does not touch
the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Switch off Extra Freeze function or
Extra Cool function manually, or
wait until it deactivates automatical‐
ly. Refer to "Extra Freeze function"
or "Extra Cool function" section.
Refer to the "Closing the door" sec‐
tion.
Let the food cool down before stor‐
age.
Store less food at the same time.
Open the door only if necessary.
Refer to the "Extra Freeze function"
section.
ENGLISH
41

Werbung

loading