Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Only one light is
flashing four times
per cycle.
Display (See Fig. H)
The RUNNING indicator light (green) is illuminated
when the machine is operating normally.
If kickback occurs, the machine will stop and the
KICKBACK PREVENTED indicator light (blue) will be
illuminated.
When kickback occurs, release the throttle trigger
and lift the machine, then re-start and re-operate the
machine again.
When the machine fails or is overloaded, the machine
will stop and the FAULT/OVERLOAD indicator light
(red) will be illuminated.
Release the throttle trigger and lift the machine, then
re-start the machine. If the problem persists, contact
your service agent.
How to use your earth auger
•
Maintain a firm grip on the handles with both
hands.
•
Make sure your footing is firm. Keep feet-shoulder
width apart. Distribute your weight evenly on both
feet.
14
•
Place the machine vertically on the ground with
the auger bit facing downwards.
•
Clean the debris around the auger bit to keep it
sharp.
NOTE: Switch off the machine before cleaning the
debris.
6. MAINTENANCE
WARNING: Remove the battery from the
machine before carrying out any adjustment,
servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the
ventilation slots, this is normal and will not damage
your power tool.
(1) Do not attempt to repair the machine unless
you have the proper tools and instructions for
disassembly and repair of the machine.
(2) Check bolts at frequent intervals for proper
tightness to ensure that the equipment is in safe
working condition.
40V 20cm Cordless Brushless
Earth Auger
The machine is over load.
Raise the cutting height or
push slowly.
7. STORAGE
1. Allow the motor to cool and clean the earth auger
before storing or transporting. Be sure to secure
the unit while transporting.
2. Remove the battery pack from the earth auger.
3. Inspect the earth auger carefully for worn, loose,
or damaged parts. Check connections and
screws and tighten if necessary. For repairing or
replacing parts, contact your service agent.
4. Store the unit, along with the removed battery
packs, in a locked, dry place out of the reach of
children to prevent unauthorized use or damage.
Cover loosely with a tarp for added protection.
For battery tools
The ambient temperature range for the use and storage
of tool and battery is 0 °C~45 °C.
The earth auger may not properly start if its battery
temperature is -20°C or less. If the machine doesn't
start, remove the battery from the earth auger and allow
it to warm indoors for 10 minutes or longer. Reinstall
the battery and try again.
The recommended ambient temperature range for the
charging system during charging is 0 °C~40 °C.
Details regarding safe disposal of used batteries
At the end of the life of the tool, remove the battery
pack safely before disposing of the tool. Do not
throw batteries away or throw them in the normal
trash can. Also do not dispose of the battery with the
machine. Remove the used battery pack from the
tool and dispose of it at the nearest or convenient
dedicated recycling facility. If in doubt, consult your
local environmental protection department. Batteries
may enter water cycle if disposed improperly, which
can be hazardous for ecosystem. Do not dispose of
waste batteries as unsorted municipal waste.
8. ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
EN
Werbung
