Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Explanation:
A traditional sanding disc is used up in a constant curve and you see how much is has been used and how much life is left in
it. Opposite to this is phase 1 in which the belt works with no usage visible for a long time. The change to phase 2 and quickly
to phase 3 comes sudden and is considered normal.
Our Tip:
If efficiency of the belt drops, look at the belt and if phase 2 starts change the belt. Increasing the pressure as well as
incorrect use are reducing the life of the belt in phase 1. Again we want to point out that the life of phase 1 can be extended
with resharpening as mentioned in phase 2.
Storage and Handling of Accessories
To help maintain performance and extend product life, always store wire belts and rubber eraser wheels in a clean and dry
location. However, keep in mind that even when the products are stored in an appropriate dry location, they can still be
exposed to significant or extreme temperature and humidity. If this is the case, allow the product to reach normal ambient
temperature before putting into use.
ZCTCRUD861CE Rev B
Phase 1
EN
EN
Phase 3
Phase 2
14
Fig.10
(07/24)
Werbung
