Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b)
Keep unused equipment out of the reach of children and out of the reach of
anyone unfamiliar with the unit or this instruction manual. These units is
dangerous in the hands of inexperienced users.
c)
Keep the unit in good working condition.
d)
Keep the unit out of the reach of children.
e)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
f)
To ensure the designed operational integrity of the unit, do not remove
factory-installed covers or loosen screws.
g)
When transporting or moving the unit from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the unit is used.
h)
Do not move, shift, or rotate the machine while in operation.
i)
Clean the unit regularly to prevent permanent dirt build-up.
j)
The unit is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
k)
Do not tamper with the unit to alter its performance or design.
l)
Keep the unit away from sources of fire and heat.
m) Check the condition of the door and observation window regularly for any
scratches or other damage. If any damage is found on the door or window,
creating negative pressure in the unit is prohibited. This also applies to the
other functional elements of the unit.
n)
Use of the unit in rooms with flammable or explosive gas mixtures is
prohibited. The unit is not designed as explosion-proof. When switching the
unit off / on, ignition / explosion may occur due to an electric arc generated in
the main switch of the unit.
o)
Pay particular attention to the physical and chemical properties (e.g. flash
point, etc.) of the contents of the oven. Paints, enamels or other similar
materials, whose reagents may form an explosive mixture with air, must not
be dried, evaporated or fired. There must be no situation in which flammable
gas or a flammable gas-air mixture is formed in the chamber of the vacuum
oven or in its immediate vicinity.
p)
When starting the vacuum oven for the first time, ensure constant supervision
of the operation of the unit until stable operating conditions are achieved.
q)
Large amounts of dust or corrosive vapors inside the drying chamber or around
the unit can produce deposits inside the unit and lead to short circuits or
damage to the electronics. Therefore, it is important to take all appropriate
precautions against excessive accumulation of dust or corrosive vapors inside
and outside the unit.
r)
In order to ensure proper air circulation in the drying chamber, sufficient
clearance must be provided between the load and the walls inside the
chamber. Do not place any load on the bottom, side walls, or ceiling of the
chamber.
Werbung
