Electrolux EUC05002W Benutzerinformation Seite 10

10 electrolux
6. Loosen the screw fixing the foot oppo-
site the lower door hinge in order to re-
move the foot.
7. Fix the door hinge and the correspond-
ing foot on the opposite side and then
the other loosened foot at the former
place of the door hinge as shown in the
Figure.
8. Please make sure to place the low-
er foot below the door hinge. The
lower foot is recognizable by its 4
ribs on the outer surface.
9. Fix the door onto the lower hinge pin.
10. To fit top door hinge, remove the plas-
tic blanking plugs carefully, and refit
them in the holes left by the hinge re-
taining screws.
11. Refit the top hinge using the 2 retaining
screws, taking care that the edge of the
door is parallel with side of the cabinet.
12. Replace the hinge cover.
13. Relocate the handle and the plastic
plugs to the opposite side.
14. Level the appliance, wait for at least
four hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.