Service Mode; Adjustment Of Movement Detection Sensitivity - Renault 6825 Betriebsanleitung

10. SERVICE MODE

If you are using the transmitter in Main-libre mode and you need to have your vehicle serviced but you prefer not to leave the transmitter
with it, this quicker procedure will allow you to temporarily disable automatic arming/disarming and the anti-hijack function without entering
the selection procedure (Service set-up).
Turn ignition on and press push-button n. 2 of the transmitter.
audible signal.
The Main-libre operation mode will be reinstated the fi rst time push-button n. 1 is pressed again. In the meantime you will hear four short
sharp audible reminder signals every time ignition is turned off.

11. ADJUSTMENT OF MOVEMENT DETECTION SENSITIVITY

The movement detector can be adjusted to 8 different levels of sensitivity to displacement + 8 different levels of sensitivity to shock. Normally
it is fi ne-tuned for optimal performance by the installer during the fi nal testing, but the procedure is simple and sensitivity can be modifi ed
by the user if required.
1. While the system is disarmed, turn ignition on.
2. During this lapse of time, press push-button n. 1 of the transmitter.
of adjustment of the sensitivity to displacement (e.g. towing / lifting).
3. Press push-button n. 1 to increase sensitivity.
Press push-button n. 2 to decrease sensitivity.
The minimum and the maximum sensitivity levels are signalled by 3 audible signals in sequence.
4. Once the appropriate sensitivity level has been selected, turn ignition off, then turn it on immediately again.
confi rms you have entered the procedure of adjustment of the sensitivity to shock.
5. Operate as described at pos. 3).
6. Once the appropriate sensitivity level has been selected, turn ignition off.
procedure.
To test the movement sensor and determine the optimal sensitivity level more easily, you can simulate displacement / shock before quitting
the procedure; if the sensitivity is suffi cient to trigger the unit, you will get a sharp audible signal (instead of a full alarm cycle).
Remarks:
• To ensure accurate adjustment, avoid generating shocks while selecting the level of sensitivity to displacement.
• It is recommended to evaluate the optimal sensitivity levels once both adjustments have been set, before quitting the procedure.
The system sets itself to service mode. This is confi rmed by a short sharp
20 s later the LED lights up and remains on for 3 s.
A sharp audible signal confi rms you have entered the procedure
A short sharp audible signal confi rms the success of the operation.
A short deep audible signal confi rms the success of the operation.
A sharp audible signal confi rms you have quit the selection
rev04
Operating instructions
A deep audible signal
11