Olymp HairMaster CLIPPER Bedienungsanleitung Seite 13

EXPLANATION OF THE LCD ICONS
RPM RPM
AVAILABLE TIME AVAILABLE TIME AVAILABLE TIME
Burden Status
When the fi rst three indicator lamps light up, the
burden is then normal.
If the fourth indicator lamp lights up, the blade must
be oiled.
If all 5 indicator lamps light up and a warning sound
beeps, the burden is very high. Switch off the device at once
and clean and oil the blades.
IMPORTANT: If a er cleaning the warning sound is s ll
beeping, check for correct installa on. If the signal con nues
to beep, the shaving head must be replaced.
Speed
The speed can be adjusted in steps of 500 with
between 5,000 – 7,000. The HairMaster®CLIPPER maintains
a constant rota on speed with diff erent hair structures
thanks to intelligent speed regula on.
Charging icon
15 minutes before the end of the device run me, the
charging symbol lights up and warning sounds beep un l
charging begins.
Oil warning indicator
A er a running me of 60 minutes, an oil warning indicator
appears and a warning sound beeps. Please oil the shaving
head.
Remaining run me
Shows the remaining run me of the device in minutes.
RPM RPM RPM
AVAILABLE TIME AVAILABLE TIME
+ -
and
ADJUSTING INSTRUCTIONS
Push the adjus ng lever upwards to
reduce the hair length.
Push the release key downwards to
increase hair length.
4 length se ngs are possible.
(1.0 mm; 1.3 mm; 1.6 mm; 1.9 mm)
INSTRUCTIONS FOR USE OF THE COMB ADAPTER
Hold the corresponding comb
adapter on both sides as shown
in the picture on the le and
place it into the locking slot.
(If fi ed correctly, the comb
adapter is held fi rmly in place
and cannot fall off .)
Please note:
Please exercise care with the sharp blades when trimming or
cu ng hair close to the ears. Protect the ear against injury
by holding your hand over it before cu ng.
CLEANING INSTRUCTIONS
GB
12