Installation; Chimney Pot - EdilKamin bering Betriebsanleitung

nel and a declaration of conformity must be issued pursu-
ant to Min. Decree 37 ex Law 46/90.
All local and national laws and European standards must be
laws in force in the country concerned are followed.
VERIFICA DI COMPATIBILITA' CON ALTRI
DISPOSITIVI
The boiler must NOT be installed in the same room as B type
which use aspiration hoods) because the boiler can create low
pressure in the room and thereby compromise the functioning
VERIFYTHE POWER SUPPLY
CONNECTION
(the plug must be accessible)
The boiler is supplied with a power cable that is to be connec-
thermic switch.
Voltage variations of more than 10% can affect the correct
functioning of the boiler.
The electrical system must comply with the law; particularly
The power line must have a suitable cross-section for the boiler
power.
An inadequate earthing system can cause anomalies for which
Edilkamin cannot be held liable.
FIRE SAFETY DISTANCES AND LOCATION
For correct operation the boiler must be level.
be installed in compliance with the following safety conditions:
ity of the boiler.
insulating material must be placed between the boiler and the
at the front.
Flammable objects must not be placed above the boiler or at a
distance that is any less than the stipulated safety distances.
the smoke exhaust pipe must be appropriately insulated with
AIR INLET: to be mandatorily implemented.
The room where the boiler is placed must have an air inlet with
air supply to the boiler for combustion.
may be condensation problems and it is necessary to protect
least 12 cm². The pipe must be less than 1 metre long and have

INSTALLATION

SMOKE OUTLET
-
The smoke is discharged through the 8 cm diameter outlet
at the back of the boiler. A T-junction must be set up with a
condensation collection stopper at the beginning of the verti-
cal section. The smoke outlet must be connected to outside by
-
The pipe must be hermetically sealed. The material used to seal
temperatures (high temperature silicone or mastic).
The only horizontal section allowed may be up to 2 m long.
The vertical duct can be internal or external.
If the smoke channel (part of the pipe that goes from the boiler
latter must be suitable for solid fuel.
If it is wider than 150 mm in diameter it must be improved by
-
entering a pipe that has a suitable cross-section and is made of
suitable material (e.g. 80 mm diameter steel).
All sections of the smoke duct must be accessible for inspec-
allow for cleaning.
The boiler is designed to function in all weather conditions.
ce Centre.
TYPICAL EXAMPLES
-
Fig. 1
A:
B:
C-E: air intake from outside (through section at least 80 cm²)
D:

CHIMNEY POT

The main characteristics are:
- an outlet cross-section which is no smaller than twice that of
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind..
- 36
-
-
-
-
Fig. 2