Blade Tracking Adjustment; Feed Speed Adjustment - Jet MBS-708 CS Gebrauchsanleitung

Fig 8
Loosen blade guides (A, Fig 8) by
loosening screws (B). Slide blade
guides away from the blade.
(MBS-910 only).
Loosen locking nuts with a hex
wrench.
Turn eccentric shaft (C) to adjust
bearing to a clearance of 0,05mm.
Tighten nut to lock.
Slide blade guides (A) back into
contact with the blade and tighten
screws (B).
(MBS-910 only).

7.5 Blade tracking adjustment

Warning:
Blade tracking adjustment requires
running the saw with the wheel
cover open. This adjustment must
be completed by qualified persons
only.
Failure to comply may cause
serious injury!
The blade tracking has been set at the
factory and should not need
adjustments.
The tracking is sensitive, in case of
need start with minor( ¼ turn)
adjustments.

7.6 Feed speed adjustment

You can control the sawblade
downward feeding with the valve
control knob (F) and lock the saw with
the on/off valve (G).
Fig 9...MBS-708CS
Fig 10....MBS-910CS
The cutting of thin-walled workpieces
(profiles, tubes etc.) requires slow
feeding to avoid excessive wear of
sawblade.
7.7 Vise adjustment
Use the quick lock handle (J) to open
and close the vise for clamping.
For vise adjustment use the
handwheel (I).
Fig 11
7.8 Saw arm adjustment
The saw arm can be adjusted for
square and mitre cuts.
Loosen handle (H) and move saw arm
to the desired angle.
7
Fig 12
Always check the angle setup with a
combination square against the blade
and vice.
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair
work may only be carried out after
the machine is protected against
accidental starting by pulling the
mains plug.
Repair and maintenance work on the
electrical system may only be carried
out by a qualified electrician.
Clean the machine regularly.
Only use sharp and properly set saw
blades.
Replace a defective sawblade
immediately.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
Lubrication:
Regularly lubricate the vice lead screw
with grease.
Regularly lubricate the vice guide
ways with grease.
Oil level must be up to indicator mark
in oil sight glass when saw arm is
lowered.
Hydraulic oil:
DIN 51517-2 CL ISO VG 68
(e.g. BP Energol HLP68, Castrol
Hyspin AWS 68, Mobil DTE Oil Heavy
Medium.