Werbung
Verfügbare Sprachen
Verfügbare Sprachen
blended. Hard food must be cut into
pieces (about 2 cm). Otherwise, the
motor may seize.
Note: this appliance is supplied with two
sets of blades. Check that the two
sets of blades are properly installed
on the blade shaft. Do not over-
tighten. The two sets of blades must
be installed as shown in the figure on
the right.
3. Place the lid on the container (as per the
figure), place the motor unit on the lid of
the food blender, turning the motor unit
clockwise until the two parts lock
together.
4. Connect the appliance. Press the low or high speed button to start processing.
Note: Start processing with pulse movements, rapidly pressing and releasing the speed button
until obtaining the desired consistency. After placing the food in the container, if the blades are
not working properly disconnect the unit and remove some of the food, then continue.
5. After use, disconnect the appliance and wait for the blade to come to a complete stop. Remove
the motor unit, the removable lid and the blades.
Note: Always check that the motor unit is in position, otherwise it will not work.
6. After processing, the non-slip mat can also be used as a lid for the container.
7. After use, disconnect the appliance from the power supply and remove the motor body with a
counter-clockwise motion. Remove the lid, the blade assembly and food, then clean as described
in the section, "CLEANING AND MAINTENANCE".
If food builds up around the blades during use:
1. Release the speed button and wait for the blades to completely stop.
2. Remove the motor unit and processing lid.
3. Use a spatula to carefully remove the food. Do not use your fingers because
the blades are sharp!
4. Once the food has been removed and the blades cleaned, refit the processing
lid and motor unit and continue processing.
Foods
Vegetables (cut into 2cm pieces)
Meat (cut into 2cm pieces)
Seasoned cheese such as Parmigiano, Grana,
Pecorino (cut into 1 cm pieces)
❖ The operating settings are indicative and may vary depending on the quality of the food and
desired results.
CLEANING AND MAINTENANCE
Before cleaning, always disconnect the food blender from the power socket and leave it to
completely cool.
Quantity
Processing time
≤200g
15 seconds
≤200g
30 seconds
≤200g
20 seconds
Speed
I
II
II
20
Werbung
