Zipper Maschinen ZI-BAS205 Betriebsanleitung Seite 39

16.5 Adjusting the saw band guide
Adjust the saw band guide only after the blade tension and the running of the saw band
have been adjusted and checked. Correct adjustment of the saw blade guide is im-
portant. The saw band becomes unusable if the teeth touch the guides while the saw
band is running.
Adjusting upper saw band guide
The upper saw band guide consists of the following components:
Rear thrust bearing
•
• Lateral guide discs
Rear thrust bearing
Lateral guide discs
Adjusting lower saw band guide
The upper saw band guide consists of the following components:
• Rear thrust bearing
• Lateral guide discs
Rear thrust bearing
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
N O T E
The thrust bearing (TB) prevents the saw blade from being
pushed back strongly during the cut.
Procedure:
• To adjust, loosen the clamping screw (CS) and position the
rear thrust bearing (TB) at a distance of about 0.5 mm
from the saw band back.
• Then tighten the clamping screw (CS) again.
The lateral guide pins should slightly strip the saw band to
obtain a vibration-free and straight cut.
Procedure:
• To adjust, loosen the clamping nuts (CN) and press the lat-
eral guide discs (GD) up to 0.5 mm to the saw band.
• Then retighten the clamping nuts (CN).
Procedure:
• Loosen the two screws (M6x20) and nuts (N). Remove the
u-shaped clamp (C) from the worktable.
• To disassemble the worktable from the bench angle
gauge (AG), loosen the three screws (M6x16), washers and
nuts (N).
• Raise the upper blade guide fully (see Fehler! Verweis-
quelle konnte nicht gefunden werden.).
• Loosen the two locking screws (LS) and remove the bench
angle gauge (AG).
• Open the lower front door.
• To adjust, loosen the clamping screw (CS) and position the
rear thrust bearing (TB) at a distance of about 0.5 mm
from the saw band back.
• Then tighten the clamping screw (SC) again.
ADJUSTMENTS
39
ZI-BAS205 / ZI-BAS250