FP FPi 5600 Betriebsanleitung Seite 98

System stops while
inserting (stoppage at
the inserting point).
Flap not sufficiently
moistened.
Envelope not always
ejected from sealer.
Fingers not correctly
adjusted.
Inserted document
too long for used en-
velope.
Envelope throat incor-
rect.
Envelope glued in-
side.
Window not glued
properly.
Water level low.
Brushes dry.
Brushes dirty.
Moistening felt dry.
Moistening felt dirty.
Brushes worn out.
Moistening felt worn
out.
Inserted document
too big.
Document not inser-
ted deep enough.
Sealing area dirty.
Check fingers posi-
tion, adjust if needed.
Check fold settings.
Check envelope spe-
cifications.
Eliminate faulty envel-
opes.
Eliminate faulty envel-
opes.
Check water level,
refill if needed.
Check brushes, re-
place if needed by the
extra soaked set.
Check brushes, clean
if needed.
Check the moistening
felt, refill water tray if
needed.
Check the moistening
felt, clean if needed.
Replace brushes.
Replace moistening
felt.
Check fold settings,
adjust if needed.
Check adjustment of
envelope stop posi-
tion and fingers.
Clean sealing area.
Adjusting the envel-
ope insert fingers on
page 37
Fold settings
Verifying the Insert
Position on page 38
-
-
Filling the Sealing Li-
quid Reservoir on
page 22
Maintenance Sched-
ule on page 80
Maintenance Sched-
ule on page 80
Filling the Sealing Li-
quid Reservoir on
page 22
Maintenance Sched-
ule on page 80
Maintenance Sched-
ule on page 80
Maintenance Sched-
ule on page 80
Fold settings
Verifying the Insert
Position on page 38
Maintenance Sched-
ule on page 80
93
9