x-sense CD01 Benutzerhandbuch Seite 3

This user manual contains important information about your carbon monoxide alarm's operation. To ensure proper use and
trouble-free operation, please read this manual careful y and store it in a safe p ace for future reference.
Introduction
A1 X-Sensecarbon monoxide alarms conform with the EN50291 Standard are designed to detect carbon monoxide.
Carbon monoxide (CO)is odorless, tasteless and invisible
can detect increased evels of carbon monoxide early, protecting your family from the dangers of carbon monoxide.
*The instal ation of the apparatus shou d not be used as a substitute for proper instal ation, use and maintenance of fuel-burning
appliances including appropriate ventilation and exhaust systems.
*This apparatus isto be instal ed by a competent person.
is not tested for use in a caravan or boat.
Note: For maximum protection, use CO alarms on each level and in every bed room of your home.
NEVER IGNORE A SOUNDING ALARM!
When CO is detected:
During the first 4 minutes, the alarm wil deliver 4 quick beeps every 5.8 seconds. After 4 minutes, the alarm wi
beeps every 60 seconds. The LED indicator will flash red with the alarm sound.
Package Contents
1 x Alarm Unit
1 x Mounting Bracket
3 x Screws
3 x Anchor Plugs
1 x User Manua
1 x Warranty Card
Technical Specifications
Power supply 10-year sealed lithium battery
Electrochemical
Sensor type
About 10 years
Product life
Safetystandards
EN 50291
it's a silent kil er. Using electrochemlcal sensing technology, this unit
• 02 •
CO sensitivity
Standby current
Alarm current
Best operating ambient temperature range
Operating relative humidity range
Alarm oudness
Si ence duration
Product Overview
deliver 4 quick
! CAUTION!
THIS CO ALARM IS DESIGNED
ALARM. DO NOT OPEN OR TAMPER
Test & Silence Button
The Test & Si ence button is used to test the unit's electronlcs and to si ence the unit during an a arm. When testing
the alarm week y, you shou d first wake up your alarm by pressing the test button; once the a arm has woken up, the
LCD display wi activate, then press the test button again unti you hear a short beep, indicating that the alarm has
entered the test mode. To save power, the a arm is designed to automatical
been no operation for 5 minutes.
Note: After a test has begun, the alarm will sound and the red LED will Rash. This does not indicate that CO is
present.
f you press the test button during an alarm state, the unit wi enter the si ence mode.
CO silence mode: pressthe test button during an alarm state, the unit wil enter the silence mode. Ifthe CO density
stil exceeds the alarm threshold within 6 m•nutes, the unit will enter another a arm state. Otherwise, the unit will exit
from si ence mode
50 ppm: 60 90 minutes
100 ppm: 10-40 minutes
300 ppm: < 3 minutes
< 6 WA (avg)
< 60 mA (avg.)
40 100 OF (4.4_37.8 0C)
s 85% RH (non-condensing)
2 85 dB at 9.84 ft (3 m) @ 32 ± 0.3 kHz pulsing alarm
9 minutes
FOR INDOOR USE ONLY. DO NOT EXPOSE TO RAIN OR MOISTURE.
WITH THE ALARM AS THIS COULD CAUSE MALFUNCTION.
after 9 minutes.
• 03 •
DO NOT KNOCK OR DROP THE
y turn off the LCD display if there has