Part Names; Remote Controller - Panasonic CZ-RWSU3 Kurzanleitung

Part Names

REMOTE CONTROLLER

One remote controller can control a group of
up to eight indoor units.
1. Operation Display
Displays the operation status. (The figure
shows all the statuses.)
• The auto-flap display may be different,
depending on the installed unit.
2. Start/Stop button
Pressing this button once starts and
pressing again stops the operation.
3. Fan speed button
4. Swing/Wind Direction button
5. Timer setting button
Use for operating with a timer.
6. Reset button
Use this button after changing the batteries.
7. Cover
Press at the top center and then slide
down.
8. Transmitter
9. Remote control sensor
Detects the temperature at the remote
controller when detection has been
switched to the remote controller by the
sensor button.
10. Temperature setting buttons
raises the temperature setting 1 °C
at a time.
lowers the temperature setting 1 °C
at a time.
4
1
2
3
4
5
6
7
11. Filter button
Press to turn off the filter lamp on the
receiver.
12. Mode Select button
Press to switch the operation mode.
13. Ventilation button
Use this when connected to an aftermarket
fan. Pressing this button starts and stops
the fan. When the air conditioner is started
or stopped, the fan starts or stops at the
same time. (
the remote controller when the fan is
operating.)
14. Address button
15. Sensor button
Used this to activate the temperature
sensor on the remote controller instead of
the one on the indoor unit. The temperature
sensor on the indoor unit is selected before
shipment. At this time
display.
16. Clock button
Use this to set the clock.
From this page, the names of remote
controller's buttons will be indicated with the
above illustrations.
E.g.: Start/Stop button 
8
9
10
11
12
13
14
15
16
CZ-RWSC3
appears on the display of
is shown on the