Napoleon PRO285X Bedienungsanleitung Seite 11

Drip Pan: Accumulated grease is a 昀椀re hazard. Clean the drip pan frequently to avoid grease buildup.
Grease and excess drippings pass through to the drip pan, located beneath the gas grill and accumulate.
To clean, slide the drip pan free of the grill. Never line the drip pan with aluminum foil, sand or any other
material as this could prevent the grease from 昀氀owing properly. The pan should be scraped out with a
pu琀琀y knife or scraper.
!
CAUTION!
Cleaning The Outer Grill Surface: Do not use abrasive cleaners or steel wool on any painted, porcelain or
stainless steel parts of your Napoleon Grill. Doing so will scratch the 昀椀nish. Exterior grill surfaces should be
cleaned with warm soapy water while the metal is s琀椀ll warm to the touch. To clean stainless surfaces, use
a stainless steel or a non-abrasive cleaner. Always wipe in the direc琀椀on of the grain. Over 琀椀me, stainless
steel parts discolor when heated, usually to a golden or brown hue. This discolora琀椀on is normal and does
not a昀昀ect the performance of the grill. Porcelain enamel components must be handled with addi琀椀onal
care. The baked-on enamel 昀椀nish is glass-like, and will chip if struck. Touch-up enamel is available from
your Napoleon Grill dealer.
Maintenance Instruc琀椀ons
We recommend this gas grill be thoroughly inspected and serviced annually by a quali昀椀ed service person.
At all 琀椀mes keep the gas grill area free from combus琀椀ble materials, gasoline and other 昀氀ammable vapors
and liquids. Do not obstruct the 昀氀ow of ven琀椀la琀椀on and combus琀椀on air.
WARNING!
WARNING!
possibility of burns, maintenance should be done only when the grill is cool. A leak test must be
!
performed annually and whenever any component of the gas train is replaced or gas smell is present.
Burner: The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive
environment can cause surface corrosion to occur. This can be removed with a brass wire brush.
CAUTION!
Spiders and insects are a琀琀racted to the smell of propane and natural gas. The burner is equipped with an
insect screen on the air shu琀琀er, which reduces the likelihood of insects building nests inside the burner
but does not en琀椀rely eliminate the problem. A nest or web can cause the burner to burn with a so昀琀 yellow
or orange 昀氀ame or cause a 昀椀re (昀氀ashback) at the air shu琀琀er underneath the control panel. To clean the
inside of the burner, it must be removed from the gas grill: Remove the screw (s) that a琀琀ach the cross light
bracket and the burner to the base. Slide the burner back and upwards to remove. Cleaning: Use a 昀氀exible
venturi tube brush to clean the inside of the burner. Shake any loose debris from the burner through the
gas inlet. Check the burner ports and valve ori昀椀ces for blockages. Burner ports can close over 琀椀me due to
cooking debris and corrosion; use an opened paperclip to clean them. The ports are easier to clean if the
burner is removed from the grill, but it can also be done with the burner installed.
CAUTION!
Ensure the insect screen is clean, 琀椀ght, and free of any lint or other debris.
Reinstalla琀椀on: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace cross light bracket and 琀椀ghten screws to complete reinstalla琀椀on.
N415-0437CE-GB-DE REV - AUG 31.22
Ensure drip pan is empty and clean before transpor琀椀ng grill in ver琀椀cal posi琀椀on.
Always wear protec琀椀ve gloves and safety glasses when cleaning your grill.
Turn o昀昀 the gas at the source and disconnect the unit before servicing. To avoid the
Beware of Spiders.
Take care not to enlarge the holes.
11
EN
www.napoleon.com