Panasonic CZ-RTC2 Bedienungsanleitung Seite 16

5. Outing Function (Continued)
• Setting the Outing Function
1. Press and hold
the upper limit temperature setting screen.
, and the upper limit temperature start fl ashing.
(The default value of the upper limit temperature is 38 °C.)
2. Press /
and press to fi x the value. The lower limit temperature
setting screen is displayed.
3. Press /
and press to fi x the value. The outing function setting
is completed. (The default value of the lower limit temperature
is 10 °C.)
* The unit returns to the normal mode if
3 minutes during the setting. In this case, all the settings in progress will be lost.
• Canceling the outing function
Press and hold for more than 2 seconds while the outing function is set.
• Outing function indication
Outing function
indication
Off The outing function is not set.
Flashing The outing function is now being set, or under operation.
Lighting Although the outing function is set, not under operation.
Note
A remote controller loses outing function operation information when it is cut for more than one hour
during the outing function operation by electricity. It reverts from the blackout, and an air conditioner
does not drive in outing function when operation is started. At this time, an air conditioner does not stop
at outing function.
for more than 2 seconds to display
to select the upper limit temperature,
to select the lower limit temperature,
is pressed or there is no operation made for
Status
EN-12
1 2,3
2 3
2,3