Toshiba MMD-AP0481HFE Installationshandbuch Seite 11

Installation of indoor
1. Install temporarily the indoor unit.
• Attach the hanging bracket to the hanging bolt.
Be sure to fix the hanging bracket from both up
and down sides of the hanging bracket by using
the nuts (MIO procured locally) and the washer.
2. Using nut, adjust height of the main unit.
3. Check the main unit is horizontally installed.
• Attach canvas ducts (procured locally) to the air
inlet and the air outlet
main unit does not travel to the duct or ceiling.
Attach also acoustic-absorption
inner liner of the duct and the vibration-proof
rubber to the hanging bolt.
Make sure that the unit is hanging level.
If it is hung horizontally, the drain pan may overflow. Install the unit within the dimensions indicated below.
Front
0 to 5mm
Install the main unit within 5mm while lowering
the drain pipe connecting port side slightly.
Using a level vial or vinyl hose, check whether the indoor unit is hung horizontally or not.
unit
so that vibration of the
material to the
A
view
Level vial
Thermal insulation
Main unit
CAUTION
Level
±5mm
Install both air inlet and air supply port sides
within ±5mm.
8
Hanging bolt
Nut (Upper side)
Washer (Upper side)
Thermal insulator
(Hanging bracket main unit)
Washer (Lower side)
Nuts (Lower side)
Side view
vial
Water pouring
Vinyl hose